ASTM A is the specification that covers the general requirements for flat- rolled stainless and heat-resisting steel plate, sheet and strip. It does not reference. 1 This specification is under the jurisdiction of ASTM Committee A01 on Steel, product specifications that reference Specification A/. ASTM A/AM Standard Specification for General Requirements for Flat -Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and.

Author: Mazukazahn Yozshushura
Country: Lebanon
Language: English (Spanish)
Genre: Technology
Published (Last): 20 October 2010
Pages: 413
PDF File Size: 12.12 Mb
ePub File Size: 14.91 Mb
ISBN: 175-1-24201-280-5
Downloads: 2656
Price: Free* [*Free Regsitration Required]
Uploader: Zulkishicage

ASTM A Specification | Penn Stainless Products

It is permitted to obtain such specimens from specimens selected for mechanical testing. In case of dissatisfaction with the results of the test, the seller is permitted to make claim for a rehearing within that time. The characters shall be of such size as to be clearly legible.

Notwithstanding the absence of a signature, the organization submitting the EDI transmission is responsible for the content of the report. When polished on one side only, it is permitted to rough grind the other side in order to obtain the necessary? This is a dull, nonre?

ASTM Specification A – What is it? – NKS

Heat treatment thermal cycles aztm be separate from other thermal processing cycles; for example, in-process thermal cycles are not permitted asym a substitute for the separate annealing cycle. Permission rights to photocopy the standard may also be secured from the ASTM website www. Interspersement of different melts is permissible if they are of approximately the same nominal thickness and are heat treated in the same operating period and under the same conditions time and temperature.

  FREENAS 0.7 DOCUMENTATION PDF

Material Test Report and Certi? When intergranular corrosion tests are required, a4480 shall be as agreed upon between the seller and the purchaser.

Finish for Strip If certifying that the material conforms to the requirements for more than one type of steel, the manufacturer may indicate each type of steel on the report, a840 may issue a separate report for each type of steel. For plates up to 10 in.

All widths and lengths 1 16 18 1 16 18 Over mm 1. This material test report shall reference the product speci? The inside of the coil shall also be marked or shall have a tag or label attached and marked with the information of Average surface roughness Ra may generally be up to 25 micro-inches. However, unless the order speci?

Historical Version s – view previous versions of standard. The applicability of these tests to duplex stainless steels not listed in Test Methods A shall be a matter for negotiation between the seller and the purchaser.

  ACTIONTEC GT701 MANUAL PDF

Committee A01 has identi? The presence of an unspeci? Referenced Documents purchase separately The documents astj below are referenced within the subject standard but are not provided as part of the standard.

ASTM A480 Plate Thickness & Flatness Tolerances

C Not including hard tempers of 2xx and 3xx series, dead-soft sheets, and deep-drawing sheets. B For circles, the over thickness tolerances in this table apply to the diameter of the circle corresponding to the width ranges shown. Heat and product analyses shall conform to the chemical requirements for each of the specific elements.

Thickness tolerances given in mm unless otherwise indicated.

TR Finish—See Note 4. Finishes for plate are actually shown in Section Approved November 15, Edges for Cold-Rolled Strip This standard has been approved for use by agencies of the Department of Defense.

For S, the heat treatment is atsm This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?

NOTE 2—If the longer dimension is under 36 in.